ASN-91 computer.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17

MIL-G-85231(AS)

4.3 Inspection conditions.

Unless otherwise specified herein, all

inspections shall be performed in accordance with the test conditions

specified in 3.3.10 and 3.3.11.

4.4 First article inspection.

First article inspection shall be

conducted by the contractor on a control group representative of the

production control groups to be supplied under the contract. First article

tests shall be accomplished under the approved test procedures (see 4.9).

Column I of table VII lists minimum tests required for first article

inspection. No first article inspections shall be conducted prior to

acceptance of first article test procedure by the procuring activity (see

6.2.2).

4.4.1 First article test data. Data collected in conducting ftrst

article tests shall be made available to the procuring activity (see 6.2.2).

4.4.2 Scope of first article tests. First article tests shall include

all tests deemed necessary by the procuring activity to determine that the

control group meets all the requirements of this specification and the

contract. First article tests shall include environmental tests in accordance

with the procedures of MIL-T-5422 and interference tests in accordance with

MIL-STD-461.

4.4.3 First article approval. Approval of first article sample will be

by the procuring activity upon completion of all tests and the first article

test report being made available (see 6.2.2). No production control groups

shall be accepted by the government prior to approval of the first article

sample.

4.4.4 Production control groups. Control groups supplied under the

contract shall in all respects, including design, construction, workmanship,

performance, and quality, be equal to the approved first article sample. Each

control group shall be capable of successfully passing the same tests as

imposed on the first article sample. Evidence of non-compliance with the

above shall constitute cause for rejection of a control group and of control

groups already accepted by the Government. It shall be the obligation of the

contractor to make necessary corrections as approved by the procuring

activity.

4.5 Quality conformance Inspection. The contractor shall furnish all

samples and shall be responsible for accomplishing the quality conformance

inspection. All inspection and testing shall be under the supervision of the

government inspector. The contractor shall prepare and make available test

reports showing quantitive results for all quality conformance tests (see

6.2.2). Such reports shall be signed by an authorized representative of the

contractor or laboratory, as applicable. Acceptance or approval of material

during the course of manufacture shall not be construed as a guarantee of the

acceptance of the finished product. Quality conformance inspection shall

consist of the following: